Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news


  

Author Topic: D9200 Horizontal Collapse  (Read 146 times)

0 Members and 1 Guest are viewing this topic.

brad808

  • (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 737
D9200 Horizontal Collapse
« on: July 12, 2016, 08:36:12 pm »
Have a WG D9202 I'm repairing for someone. Got the monitor and it wasn't powering on, would just go right into HV shutdown. Had a whole whack of stuff out.

Replaced:

Yoke connectors
Q418
Q413
Q414
R462
R854

Now I have power but I'm left with Horizontal collapse (straight vertical line). Looking at troubleshooting guide it says: Q413, R462, R424, IC404,
R415, Q418 R462 (OPEN), R424 (SHORT)


Any other suggestions?
vr402 has good ground,R462 - 1 ohm, R415 - 22ohms, Can't seem to find R424 anywhere... any hints?


IC404 Reads:
Pin 1 - 3.75 VDC
Pin 2 - 0.64 VDC
Pin 3 - 0.25 VDC
Pin 4 - 2.04 VDC
Pin 5 - 0 VDC
Pin 6 - 0.3 VDC
Pin 7 - 20.65 VDC
Pin 8 - 5 VDC

brad808

  • (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 737
Re: D9200 Horizontal Collapse
« Reply #1 on: July 12, 2016, 09:47:53 pm »
Can't seem to find R424 anywhere... any hints?




Finally found R424, it checks good at 50kohms

  
 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31